Ek auto to manual reverse light

Manual Reverse Light Lamp Package. $ inc GST. On offer here is a perfect reproduction of the original FB and EK manual models “Backup Lamp Package” as offered by Nasco under part number Add to cart. SKU: E Category: EK Holden.  · *Run the green wire at #4 and the yellow at #5 to the reverse plug b/c the reverse lights won't work unless you run the wires though the firewall to the plug. *Cruise control I don't have, so I didn't have to use it but wire the #7 wire and the #13 wire to the switch on the clutch assembly.  · it's a matter or wiring the reverse sensor on the trans to the wiring in the center console area for the old auto shifter assembly. tie them in together and your reverse lights will work. Again, check a shop manual for diagrams and correct wire colors of how to connect them.

not sure about the '67 cars, but in newer cars with a column mounted ignition switch, the actual switch is on the column up under the dash. floor shift cars (manual and automatic) had a linkage (called a back drive linkage) that went up from the trans to the column to activate the reverse lights and allow the key to go to the "lock" position. MKIII Born with Auto Transmission, Swapping to Manual Transmission. Mechanical. Remove auto shifter assembly. Remove flex plate from motor. Install flywheel. Use new hardware, OEM () or ARP P/N# (Comes in pack of 8 or Driftmotion sells 6 of them) Install new pilot bearing OEM (). Honda EK Joined Nov 4, Messages As for your question of auto to manual, the only aspect of that i've not seen covered before will be changing out the auto shifter for a manual one. i also did the auto to manual conversion on my eg6 sir the only real annoyin bit was wirin in my reverse lights as i kept the auto.

Wire up reverse lights, and cross a few wires so the car thinks its in neutral the entire time so it can be started and key can be removed. Install new shift boot, and shift knob (shifter should be attached to linkage already). Replace interior. Rewire IACV if need be Replace auto ECu with 5spd unit. Start car up and drive away. IACV Repinning. Re: Auto to Manual K swap Reverse LIghts Never mind guys, I figured it out. Pretty simple really. Here are the steps: Locate the RSX C gray plug. Cut Pin 1 2. Pin 1 is for the green/black wire, Pin 2 is for the yellow/red wire.-Look for the green/black wire and the yellow/red wire on the plug that used to be plugged into the auto shifter. like ragingangel said u dont have to modify the chassis leg gbox mount on an ek thats only on eg's i also did the auto to manual conversion on my eg6 sir the only real annoyin bit was wirin in my reverse lights as i kept the auto loom an i havent got a head for wires left the gear selecter in park an changed the clocks for manual one an got a.