Follow the instructions in the installation, operating, and programming manuals. These instructions must be followed to avoid damage to the control panel and associated equipment. FACP operation and reliability depend upon proper File Size: 1MB. Consult the appropriate detector installation instructions for the applicable wiring diagram. The RTS mounts to a single gang box (2 1/2” minimum depth), or directly to the wall or ceiling. See Figure 8 for wiring diagram of RTS with Duct Smoke Detectors. In Canadian applications, the RTS is intended to be located in the same. FireLite Plus is a 5/16” (8 mm) thick laminated fire-rated and impact safety-rated glazing material. FireLite Plus must be handled with care during transportation, storage, inspection and installation. Store in a dry place. FireLite Plus shall be glazed into the appropriate fire-rated framing with an approved glazing compound (closed cell.
MS-5UD MSUD Series Manual — P/N C2 1/24/ 3 Installation Precautions Adherence to the following will aid in problem-free installation with long-term reliability: WARNING - Several different sources of power can be connected to the fire alarm control panel. Disconnect all sources of power before servicing. Control unit and associ-. MS-2 MS-4 Series Manual — P/N G2 10/18/ 3 Installation Precautions Adherence to the following will aid in problem-free installation with long-term reliability: WARNING - Several different sources of power can be connected to the fire alarm control panel. Disconnect all sources of power before servicing. Control unit and associ-. CP Plug-in Addressable Ionization Sensor Installation and Maintenance Instructions. Addressable Detectors Modules. CRF Relay Control Module Installation Instructions. Addressable Detectors Modules. Cybersecurity Manual. LSFL-E. Addressable Fire Alarm Control Panels.
MS-5UD MSUD Series Manual — P/N C2 1/24/ 3 Installation Precautions Adherence to the following will aid in problem-free installation with long-term reliability: WARNING - Several different sources of power can be connected to the fire alarm control panel. Disconnect all sources of power before servicing. Control unit and associ-. Enter '0' for fire panel only; '1' for slave communicator only; '2' for fire panel/communicator operation. Zone 1 Function Select. Enter '0' for 2-wire smoke detectors; '1' for pull station; '2' for normally open contact devices; '3' for supervisory devices; '4' for supervisory devices (auto resettable). FCPSFS Series Instruction Manual — P/N L8:J2 7/11/ 3 Installation Precautions Adherence to the following will aid in problem-free installation with long-term reliability: WARNING - Several different sources of power can be connected to the fire alarm control panel. Disconnect all sources of power before servicing. Control unit and associ-.
0コメント